Was run the command mkinitrd so it will apply the blacklist. You didn’t need to rebuild the kernel, all that was needed to be done Usbtouchscreen and install it’s calibration tools etc. OK, so I looked at the script, it uses uinput and blacklists Module Alias: “usb:v0EEFp0001d0100dc00dsc00dp00icFFiscFFipFF” Model: “D-WAV Scientific eGalax TouchScreen” Well not good news… it worked out of the box for me… Code:īus 001 Device 003: ID 0eef:0001 D-WAV Scientific Co., Ltd eGalax On Thu 03:14:02 PM CDT, malcolmlewis wrote: Module Alias: "usb:v0EEFp0001d0100dc00dsc00dp00icFFiscFFipFF"Ĭonfig Status: cfg=new, avail=yes, need=no, active=unknownĬan you post the hwinfo -usb into to see what it’s doing. Model: "D-WAV Scientific eGalax TouchScreen" UDI: /org/freedesktop/Hal/devices/usb_device_eef_1_noserial_if0 Well not good news… it worked out of the box for me… lsusbīus 001 Device 003: ID 0eef:0001 D-WAV Scientific Co., Ltd eGalax TouchScreen So now im stuck with a nother touchscreen. BUT on kernel 4.8.5 which is te one using the customer, i cannot compile it ) So the guide tells me to compile the kernel and add/remove some options using make menuconfig ( did it)Īnd then add some lines to evdev.c - mousedev.c - joydev.c ( did it and the kernel compiled with no errors. ( and i might add the network doesnt work too, still checking why) The guide tells me to compile the kernel( i did it with 3.0.101-63-pae and folloed the guideĮverythin good, kernel compiled and booted BUT the touchscreen still doesnt work. So im trying to install the touscreen (egalax) THIs is a POS from fujitsu, called TP8AS (i think this is a new version and there are no drivers on the fujitsu page) IM here again with a new POS trying to make a touchscreen work
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. Archives
January 2023
Categories |